Get same-day appliance repairs with zero service call fees when you book today. Our certified technicians fix all major appliances — fast, reliable, and guaranteed.
Looking for a dependable appliance repair team “near me” that actually shows up when they say they will? You’re in the right place. We’re a Brooklyn-based crew serving all five boroughs, focused on household electric and gas appliances only—no commercial units.
Our techs arrive with stocked vans, diagnose on site, and explain fixes in plain language. Parts are sourced through NYC distributors so you’re not waiting a week for a simple bracket or board.
We offer same day appointments whenever scheduling and parts allow, and we’re happy to work around busy apartment schedules.
Our Appliance Repair Services in Brooklyn
We handle refrigerators, washers, dryers, electric ovens, electric stoves, cooktops, and dishwashers. Every repair includes safety checks, a function test cycle, and a short care walkthrough so the fix actually sticks.
If your refrigerator hums but doesn’t cool, pulls high amps, or short-cycles with a hot sealed system line, the compressor may be failing. We test with manifold gauges, check superheat/subcool values, and verify start relay and capacitor before recommending a compressor swap. We only use EPA-approved procedures and replace the filter-drier, perform nitrogen purge, vacuum to 500 microns, and weigh in charge to spec.
Thermostat Troubleshooting
Erratic temps or frozen produce? We compare thermistor readings against control board targets and inspect damper door operation. Sometimes it’s not the thermostat at all—it’s a clogged air channel or a stuck evaporator fan, which we’ll free and test.
Water Leak Fix
Puddles under the crisper or on the floor usually trace back to a blocked defrost drain, cracked inlet line, or a weeping water valve. We steam-clear drain tubes, reseat grommets, and pressure-test lines so you don’t mop every morning. Our process is fast but careful—no mess left behind.
A no-spin condition can be a worn drive belt, failed motor brushes, or a faulty tachometer sensor. We run diagnostic modes, check error codes, and inspect spider arm corrosion on older front loaders.
Water Drainage Issues
Standing water points to a clogged coin trap, jammed pump impeller, or kinked drain hose. We clear debris (bobby pins are frequent culprits), test the pump windings, and recalibrate the pressure sensor so the control knows the tub is empty.
Control Board Replacement
Random beeps, dead panels, or cycles that restart themselves? We verify incoming voltage, inspect board solder joints for heat stress, and update firmware when available. If replacement is needed, we transfer programming and run a full self-test.
Uneven baking or no bake/broil heat often traces to an open bake element or a shorted broil element. We ohm-test elements, inspect terminal blocks for heat damage, and verify the hi-limit switch.
Digital Display Repair
Dim numbers or a dead clock usually indicate a failing display board or weak power supply capacitors. We test low-voltage rails and ribbon cables before swapping parts so you’re not replacing modules blindly.
Door Seal Replacement
A leaky gasket wastes heat and stretches cook times. We replace with model-matched seals, clean the channel, and check hinge alignment to stop heat loss.
If the drum spins but clothes stay wet, we check the heating element coil, high-limit thermostat, cycling thermostat, and thermal cutoff path. Lint-packed vents are a common NYC issue; we measure airflow and temperature rise to factory spec.
Belt and Motor Replacement
Squeals, thumps, or a drum that won’t move suggest a worn idler pulley, snapped belt, or weak drive motor. We replace wear parts and re-tension the belt to prevent early failure.
Thermal Fuse Replacement
A blown thermal fuse is a symptom, not the cause. We replace the fuse and address the root—blocked vent, failed thermostat, or grounded element—to keep it from popping again. Our scheduling is express when safety is involved.
We test element continuity and surface switch output. On radiant elements, we inspect limiter contacts and verify correct voltage at the terminal block.
Switch and Knob Repair
Loose knobs or switches that won’t click into position lead to unreliable heat. We replace worn shafts and re-seat bezels so settings are accurate.
Wiring and Connection Check
Heat can loosen terminals over time. We tighten or replace spades, inspect for charring, and verify proper cord strain relief.
We trace power from the junction box to the element, checking infinite switch output or induction board status (for electric induction only). We do not service gas cooktops.
Touch Controls Malfunction
Ghost touches or dead panels? We clean and reseat ribbon cables, update touch controller firmware when available, and replace cracked overlays.
Glass Surface Replacement
Cracked glass happens. We order the exact top by part number, transfer elements carefully, and torque mounts evenly to avoid stress points.
If water pools at the bottom, we inspect the drain pump, air gap/loop, and disposer knockout. We also clean the sump and check the check-valve flap.
Spray Arm Repair
Poor cleaning usually comes from clogged spray jets or a stripped hub. We de-scale, replace bushings, and verify pump pressure to restore full coverage.
Door Latch Fix
A misaligned latch stops cycles cold. We adjust strike plates, replace worn latches, and test for proper door switch engagement.
We level the cabinet, secure the frame with correct fasteners, and verify dedicated circuit amperage. Final step: temperature calibration bake.
Washer and Dryer Hook-Up
We balance the washer, set anti-vibration pads for older joists, and connect the dryer with a smooth-wall vent where building rules allow.
Dishwasher Installation
We align to the countertop, set anti-tip brackets, connect water with braided lines, and run a leak test with paper towel markers for peace of mind. You’ll also get a quick tutorial.
Book Online And Get $25 Off On Repair
Click here to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
Home Appliance Repair Services We Provide in Brooklyn
We provide repair and installation services for all major household appliances—refrigerators, ovens, stoves, cooktops, dishwashers, washing machines, and dryers and gas appliances. We do not service commercial equipment, focusing exclusively on electric, standard residential units.
Fridge Repair in Brooklyn
Warm spots on the top shelf, a fridge that “short cycles,” or an ice maker that overflows—each symptom points in a different direction. We diagnose failed evaporator fans, iced-over defrost assemblies, thermistors reading out of range, clogged drain tubes, door gaskets that won’t seal, and inverter-driven compressor issues.
Side-by-side, French-door, counter-depth, or bottom-freezer—after repairs we verify temps with a calibrated probe and check airflow and defrost timing. If you need a fast rescue for a melting freezer, we’ll triage to save your food when possible.
We service electric stoves (radiant or coil). Typical fixes include surface elements that won’t heat, warped burners, failing infinite switches, and control panels with unresponsive keypads. We also correct miswired 3- or 4-prong range cords and install anti-tip brackets for safety.
When the cooktop won’t respond or only heats on high, a faulty switch or relay is usually the culprit. Expect an express diagnostic, then a clear go/no-go estimate before any parts go in.
Front-load or top-load, we handle no-drain conditions (clogged coin traps, seized drain pumps), spin failures (worn drive belts, bad actuators, weak motors), and leaks traced to door boots, tub seals, or inlet valves.
We quiet down off-balance wobble by checking suspension rods or shock absorbers, and we catch early bearing wear before it turns into a tub job. After repairs we run a rinse/spin and verify fill levels, pressure switch response, and final RPMs.
Dishes coming out gritty or cloudy? We inspect spray arm pressure, circulation pumps, and the turbidity sensor that decides when the cycle is “clean enough.” Heat-related drying issues often trace back to a high-limit thermostat or heating element, and we fix latch/strike misalignment that causes maddening intermittent starts.
We’ll also address leaks (usually door gaskets or cracked sump housings) and quiet down drone noises from worn motor bearings. Ask about our free service call with repair—diagnostic fee is credited when you proceed.
We repair electric and induction cooktops (and gas). Common problems: glass tops with dead zones, burners stuck at one temperature, or induction units flashing error codes after pan detection fails. We test power modules, MOSFETs/IGBTs, and temperature sensors, replace failed elements, and reseat connectors that loosen with heat cycling.
Planning an upgrade? You can book online and get $25 off on repair—handy if your install uncovers wiring or venting surprises.
Uneven bakes or long preheats usually point to a weak bake element, misreading temperature sensor (NTC), or a failing electronic control. We calibrate to within a tight tolerance so your sourdough or lasagna doesn’t become a science experiment.
For convection models, we replace noisy or slow fans and ensure the control board actually uses the fan curve it claims. Afterward we run a 350°F test, confirm preheat time, and verify actual vs. displayed temperature.
We service electric dryers only. No-heat complaints often trace to a blown thermal cutoff, open heating element, or a high-limit thermostat tripping due to poor airflow.
We clean internal lint paths, replace worn idler pulleys and drum rollers to stop thumping, and fix moisture sensors so “auto-dry” stops guessing.
We also correct venting issues (crushed foil duct, too-long runs) and reseal drum felts to keep clothes from snagging.
Upgrading your kitchen or laundry? We install electric ranges, wall ovens, cooktops, dishwashers, refrigerators with water lines, and electric dryers. That includes leveling, anti-tip brackets, new fill hoses with stainless braided lines, dishwasher air-gap or high-loop setup, and proper 4-prong cord conversions where required.
We pressure-test dishwasher connections, run a full rinse to check for leaks, and verify refrigerator temps and ice maker fill after installation.
Express Repair in Brooklyn is proud to be a HomeStars Award winner every year from 2018 to 2025 — a testament to our consistent commitment to quality and customer satisfaction. This recognition reflects the trust homeowners in Brooklyn and beyond have placed in our appliance repair services year after year.
Book Online And Get $25 Off On Repair
Click here to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
Need it handled today? Our routing is built for same day visits across most Brooklyn neighborhoods, and our vans arrive pre-stocked with high-use parts to finish in one trip. We protect floors, document findings, and test every function before we leave.
Certified Technicians with Real Experience
Your appliance is serviced by factory-trained techs who troubleshoot, not just swap parts. They’re fluent in brand quirks, from control board glitches to sensor calibration. Book online and get $25 off on repair—easy scheduling, instant confirmation.
We Repair More Than Just Common Problems
Beyond “no heat” or “won’t drain,” we tackle intermittent faults, error codes, and complex electronic failures that others decline. Our express diagnostic process isolates the root cause quickly, then we show you options by cost and turnaround. No surprises, just informed decisions.
Local, Trusted, and Always Nearby
We’re a true neighborhood team—familiar with co-ops, brownstones, walk-ups, and everything in between. When you search “appliance repair near me,” you get people who actually show up on time, communicate clearly, and clean up after the job. Most new calls come from referrals, which says a lot.
Reviews of our customers
Excellent
★★★★★
4.8 | 175 reviews
Dryer had no heat; they tested the element and thermostats, found a blocked vent, and fixed the root cause. The follow-up tips to prevent lint buildup were super helpful. Great service.
David R.2025-04-09
Booked a same-day slot and the technician arrived on time, wore shoe covers, and fixed my electric oven without upselling. Clear pricing, fast diagnostics, and a clean workspace when he left. Would use again.
Jordan M.2025-08-19
Our condo washer wasn’t draining. Tech cleared the coin trap, replaced a worn pump, and ran a full test cycle. The explanation was simple, the turnaround was express, and the invoice matched the quote.
Priya K.2025-07-03
Found this company while searching for ‘appliance repair near me’ and I’m glad I did. My fridge wasn’t cooling and they showed up within hours. Fixed the thermostat fast—very professional and reasonably priced.
Marcus D.2025-06-14
My electric cooktop’s front burner wouldn’t heat. Tech traced it to a failed switch, replaced it in one visit, and verified all connections. Fast communication and an easy online booking experience.
Find answers to commonly asked questions about our services.
Do you actually serve my neighborhood in Brooklyn?
Yes—Brooklyn Heights, Williamsburg, Park Slope, Bushwick, Bed-Stuy, Crown Heights, Downtown, Bay Ridge, Sheepshead Bay, and beyond. If you’re searching “near me,” we’re already nearby with stocked vans and building-friendly techs.
Can I get a same day appointment?
Often, yes. Morning calls are the easiest to route; we’ll text a live ETA and update your window if a prior job runs long. If parts are needed, we source locally to keep momentum instead of pushing to next week.
How fast is the diagnosis?
Most issues are identified in the first visit because we carry common sensors, pumps, heaters, belts, control boards, and door gaskets. The workflow is fast, but thorough—visual inspection, electrical testing, and a functional cycle before we call it fixed.
How much does appliance repair cost?
Transparent line items: diagnostic, parts, labor. No surprise “shop fees.” You’ll see the quote before any work begins, and we’ll explain cheaper vs. long-term options (repair vs. replace) if your unit is near end-of-life.
What do you mean by express service?
“Express” means priority scheduling for no-cool fridges, flooded washers, or safety-critical faults. We reshuffle the route when food loss or active leaks are at stake and keep you posted step-by-step.
Is there a discount if I book online?
Yes—book online and get $25 off on repair. The booking form also lets you upload photos, model numbers, and error codes so we pre-stock the right parts.
What kind of warranty do you provide?
Standard 90-day labor warranty plus manufacturer warranty on parts. If the same issue reappears within the warranty window, we prioritize your return visit and re-test the entire failure chain, not just the replaced part.
